Plumbing Inspection checklist

Check for leaks around the water meter body, connections, and curb stop valve Verify the meter dial is moving smoothly when the water is running

Ensure all shutoff valves (main, individual fixture) function smoothly Check for leaks around the valve stem or packing nut when closed

Thoroughly inspect toilets, sinks, floors, showers, and tubs for any signs of leak Check roof drains for clogs or debris that may cause water pooling or leaks Check roof drains for clogs or debris that may cause water pooling or leaks

Inspect all visible pipes, fittings, and connections for signs of leaks, water stains, moisture patches, or mold growth Look for pinhole leaks (small rust spots) on galvanized pipes Check for corrosion on exposed pipes, especially around joints Look for calcium deposits around faucets and valves (possible hard water issue) Test water pressure at various points (kitchen faucet, bathroom faucet, hose bib) using a pressure gauge (ideally 40-60 psi) Recommend pressure regulator installation if pressure is too high Investigate potential restrictions if pressure is too low Test all faucets for proper operation, leaks, and loose handles Check for cartridge leaks in single-handle faucets (turn off the water supply and check for drips from the spout) Verify hot and cold water function correctly (hot on the left, cold on the right) Check for mineral buildup on faucet aerators (recommend cleaning or replacement) Inspect washing machine hoses and dishwasher hoses for cracks, bulges, or wear and tear (recommend braided stainless steel hoses) Recommend hose replacement if older than 5 years old or show deterioration

Run water through all drains (sinks, showers, tubs, washing machine, dishwasher) and observe for slow drainage Listen for gurgling sounds that may indicate a vent system clog Check for leaks around the base of the toilet, especially where the flange meets the floor Check for loose connections at the toilet supply line and shutoff valve Test the flushing mechanism for proper operation (full and half flush if applicable) Look for signs of wear and tear on the flapper valve, fill valve, or flush valve handle If accessible, ensure vent pipes are properly connected and terminated on the roof Look for debris or blockages

Inspect the water heater tank, pressure relief valve discharge pipe, and T&P valve discharge pipe for leaks Look for any signs of rust or corrosion on the water heater tank Check the water heater temperature setting (ensure it's within a safe range, typically 120-140°F) Explain the risks of scalding with higher temperatures Inquire about the last time the water heater tank was flushed

Compile a detailed report outlining all findings from the inspection Include clear descriptions of any issues discovered, including leaks, corrosion, or faulty components Note recommendations for repairs or replacements, with estimated costs for each it Provide clear explanations for the homeowner regarding the necessity of repairs Include high-quality photos of any problem areas for better visualization

Pass: Meets standards Flag: Attention needed Flag: Attention needed